When installing floor which is screwed by usually 4- 6 selftappers it is best to get under with drill with very fine drill 1/16th or less and using original self tapping holes drill through new floor.
You then put in your new countersunk self tappers.
Though you don't see this often these are orginal battens under floor.
Some had small pieces about 30cm long- also have set of these.
Timber floors:
Always use correct size timber if you are replacing floor.
1. If it is remaining a camper it is easier to refit bed/seat.
2. If you are not replacing furniture you don't need wooden floor but if you decide to have this still use orginal measurements as side trim panel will not fit . Wooden floor MUST not go out to body panel even in camper.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
FAQ
Search
Memberlist
Usergroups
Join! (free) 
Profile
Log in to check your private messages
Log in
